Skip to main content

Tank Components with Reconciled Values Below Minimum or Above Maximum

This analysis rule includes the list of tank elements with reconciled component results that are below the minimum or above the maximum. When the reconciled value falls outside the range indicated by the tank analyzer's minimum and maximum, normal operating parameters have been violated. While nothing may be wrong (for example, the tank is being serviced) this situation is a gross error. This condition can indicate the following:

  • Missing data
  • Bad data
  • Invalid tank configuration

The following table lists a sample log output for this analysis.

Sample Log

TimeSeverityElementAttributeMessage
9/1/2005 10:06...REPORTING TANK COMPONENTS WITH RECONCILED VALUE BELOW MINIMUM/ABOVE MAXIMUM
9/1/2005 10:06ErrorTankAReconciledComponentResultsC3 ReconciledComponent Results= .9 above Maximum= .7

Analysis Method​

  1. Collect a list of all tank elements in the current Case that satisfy the following criteria:
  • Status Attribute value is IS (In Service).
  1. Compare the reconciled component value to the analyzer component minimum and maximum values.
  2. Write to the log section of the case. Report the violating tank information.

Configuration Using the Wizard​

The configuration of the Tanks with components with reconciled values below the minimum or above the maximum is a selection of the General Gross Error Analysis Rule. You open the window for configuring the test (shown in the following figure) from the General Gross Error Analysis Rule Wizard.

  1. Open the Gross Error Configuration window as described in Configuring - General Gross Error Analysis Rule.

  2. On the Tanks tab, select Tanks with components with reconciled values below the minimum or above the maximum.

    A Tanks with components with reconciled values below the minimum or above the maximum levels - Attributes window opens.Figure 432: Tanks with components with reconciled values below the minimum or above the maximum levels - Attributes window

  3. Select the Attributes according to the following table:

    Attributes

    SelectionsDescription
    Component ResultsAnalyzer Attribute containing component data. The default is 'ComponentData'.
    Reconciled Component ResultsTank Attribute containing reconciled component results. The default is 'SolidComponentData'.
    StatusTank in/out of service status. The default is to 'ObjectStatus'.

  4. Click OK to finish the configuration.

    The text "CONFIGURED" displays next to the 'Tanks with components with reconciled values below the minimum or above the maximum' selection.

  5. To run this test, see Running the Post Reconciliation Gross Error Analysis.